Switches - Small Business

I have a question regarding the link speeds of a laptop. I recently purchased an SG-200 18 port GB switch.  I'm having a problem with a particular laptop's network link speed. I have a laptop (running Windows 7) with a JMicron PCI Express Gigabit Eth...

Quite randomly I have my sg300-10 crash and I see this in show logging file: #show logging fileLogging is enabled.Origin id: disabledConsole Logging: Level info. Console Messages: 0 Dropped.Buffer Logging: Level info. Buffer Messages: 103 Logged, 10...

Hello, I have 4 switches stacked with a ring configuration and multimode fiber transceivers. My question is the following: 1) I must add another switch to the configuration but I cannot insert it correctly into the ring stack config because I can't ...

How is one supposed to upgrade an SG-300-52 from 1.3.0.62 to current? The release notes for 1.4.7 say: Upgrading from Versions Earlier than 1.3.5When upgrading the device from version prior to 1.3.5:    • For Sx200/Sx300 models, first upgrade the dev...

I have to connect autonomous access point in cisco sg300 28 port. The switch is not the POE, so i used the power injector for that.I have configure all the wireless configuration in access point with radio interface and all those stuff.But got a trou...

Hi I would like to know if my cisco 4948 is able to générate ip igmp request without router? I would like to maintain the ip igmp table on my network. I have some command to set ip igmp parameters but I don't know if  "ip igmp snooping querier" comm...

hi every one , i hope you guys can help me the problem to solve is exactly what i posted in title i can conect and have access to config web page for sg200-50, using the port 49 or 50, in catalyst 3750 and also in the sg200 i am using trunking ports...

 Is it possible to deny only incoming traffic to certain VLAN using IP ACL? For e.g. I want to deny all incoming traffic to management VLAN from other VLANs but want to allow managment VLAN to access all other VLANs. Is it possible? 

Hi all, I have two sg300 switches with current firmware (1.4.7.5) which I am trying to join using basic link aggregation. Additionally, one switch is set to tag all incoming traffic to VLAN10. This setup works fine when configured, but after saving a...

Why my new sg300-100 shows only 32-bit input counters in the web browser while the output counters are appropriate 64-bit in the attached picture? (Firmware Version is 1.4.0.88 15-AUG-2014.)The log server is obtaining the information from Cisco “The ...

Hello, I have an issue with the following tacacs config: enable password blabla123!aaa authentication login default tacacs enableaaa authentication enable default tacacs enableline telnet login authentication default enable authentication default pas...

My company has been having a few issues recently where SG300-28A switches 'go dead' to field locations. When they arrive back to us we take a look at them and are prompted for the MAC address, serial number, and hardware version. After a lot of fight...