Switches - Small Business

Hello, I'm trying to set a default IP address in a new SG300-28. Default IP address points to 192.168.1.254. When I try to create a new IP I'm loosing connectivity to it. Any ideas? Firmware version is 1.4.2.4. Thanks, Marcello.

Hello. Is it possible to tag native vlan on trunk port of SGE2000? I can't do that not in Web ui, nor in lcli.

Hello We’ve used SG300-20 series switches in CCTV project, there are cctv cameras (over 200) and some distributed infrastructure (topology doesn’t matter here), but at the end there is RACK 2 with NVR devices connected to SG300-20 switch, RACK 3 with...

SG200-26 firmware 1.4.0.88 Backup to Ubuntu 16.04 sshd fails when negotiating KexAlgorithms and Cyphers no matching key exchange method found. Their offer: diffie-hellman-group-exchange-sha1 no matching cipher found. Their offer: aes128-cbc,3des-cbc,...

I have a brand new SGE2010 48-port switch. I initially set my computer to 192.168.1.100 and connected to the web GUI on the switch successfully using Firefox 3.6.13 on Linux. I was able to navigate through all the settings without any problems.I upda...

Hello, I am having issues trying to web interface into a cisco SG300-10MP.  I inherited these switches after I was hired.  We have several of these switches throughout our sites.  I have tried IE (compatibility mode), chrome, FF.  The switch is locat...

what is the maximum wan bandwidth of RV042 ?

Guys, I have some IES (Industrial Ethernet Switches) in the network, and would like to know if is it possible to have two boot system images, one primary and another secondary. In fact, I can't put the config lines "boot system flash:/image_name.bin"...

Hi,I have an issue with the sf-300 switch model, which i am depolying in lapsafe trolleys. The approach is to wake the laptops from the guest VLAN (20) with WOL have them authenticate with 802.1x and use DVA to put the ports in VLAN14 so updates can ...

Hi, I try to have access to my computer (through a VPN) where Windows Server is installed by using RADIUS. I have followed this article : http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/117641-config-asa...

Hello brothersAt beginning I have add that I'm really fresh in Cisco title so it provides me so far a lot of problems.This time I try to push all VLANs  to L3 device by Trunk port but on my SF300 I can't find "encapsulation". Only possible options is...

does the enterprise transceiver are compatible with cisco small businesss switches. As the modules MGBSX1 is going EOL and the replacement is GLC-SX-MMD= Does GLC-SX-MMD will support cisco SMB switchesas 300 serie or 500 series.?

Hi,We have a issue with a sg300 switch, from some reason, we have this fatal error at the boot.RSFLEG_read: wrong input parameters !!! ***** FATAL ERROR *****We don't now why...Here is what appears on the terminal screen *****************************...

Please I need to find the right switch, with the following specifications: Managed 8-Port Gigabit SFP Standalone L3 Switch with 4 Combo 1000BASE-T Ports, IPv6 Packet Buffer 2MB MAC address Table 16K IP Routing 256 Static/ 12k Dynamic Total Aggregate...

Hi, Can an SF-200 24FP act as a DHCP server? Thanks Russ