Switches - Small Business

Hello, I have tested a script to backup the config from a SG300-10 switch but the script are not working. I tested with plink, but I can connect to the switch but the command is not running. Have someone a working script to backup the configuration f...

Hello, This is hardeep, i am using SG-300 at my plave and need to know how to use this device for dividing bandwidth between hosts.

I am looking at deploying two new SG500-28 for our servers to use. I know they come by default as L2 but what advantages would I gain from configuring them as L3. We currently have all our routing done via the gateway so I can't see the advantage ot...

I want to create a network with 4 VLANS. Core VLAN (servers, management) Data VLAN Voice VLAN CCTV VLAN I am looking at installing 2 x SG500x 24 port switches as CORE switches to connect servers and phone system. I am then looking to install 6 x SG30...

I have an SG200-08 that I need to use as an intermediate switch.  When hooked up, the attached systems have good access to the server on the lan, but cannot ping the gateway or get to the web.  I left it at the factory settings.Replacing it with an e...

I'm trying to configure VLANs on my SG300-10PP which I just purchased. Heres my configuration: GE1 is a trunk port which has a WAP on it. The WAP will tag one SSID with VLAN100. It tags another SSID with VLAN200. The WAP can produce untagged traffic...

I recently purchased an SG300 switch and was not aware that Layer 3 was disabled by default. To enable it, I'd have to reset my whole config and start over again. Is there any performance penalty to enabling Layer 3 mode on the switch? If not, then ...

Hi all, I seem to have a bottleneck with my Linksys poe+ switch, so i am looking at replacing it with the  Cisco SG110-16HP However, looking at the spec, it seems that it only support POE (af) and does not support POE+ (at)?. Is this really the ca...

I had some issues with this, and was not able to find an answer in the help or searching the web. In order to help the next person, here are the instructions:I have a brand new SG 300-20 switch, and I am attempting to add ssh to the login capabilitie...

Hello, I've searched around and can't seem to find anyone else with this problem. I've got an sg 300-20 installed in my network that is showing quite a few errors with links dropping on both the data and voice vlans. The ram log is littered with thes...

I have a problem with the cisco SG300-10MPP. I create a few Vlans. But when i want to join a port to a created vlan the box is always empty. Please the the jpg-file

i have a few SGE2000P switches and i am looking to add an alternate DNS Server to each - however i can only make one DNS server 'active'. my question is what happens if theprimary DNS server goes offline - will the 2nd DNS server come into use autom...

Hi, How do I point a vlan interface to a dhcp server on SG500?  On a 6500, I use "ip helper-address".  Trying to use the same command, however, the switch complains about "% missing mandatory parameter".  Can you please advise me? Thank you so much...