Switches - Small Business

HiWe've had a hiccup yesterday.Is this something that we need to look at closer?Stack of 2x SG500XG-8F8T, redundant connections.ThanksMichel 1474812372015-Jun-30 20:52:28Informational%AAA-I-CONNECT: New https connection for user <user>, source <ip> d...

This is probably more of a generic networking question than a Cisco specific question, I am trying to configure a SG300-10 switch in L3 mode so that the switch can handle certain types of traffic across interfaces (and subnets) without the need for i...

i have a sg500 connected to a sg300 using 802.3ad and LACP, and trunk several VLANs over the Port-Channel.  the LAGs are set in General mode.  i recently tried to turn up GVRP, so i could have the VLAN database replicated from one switch to the other...

Hi,in a remote site I have already a SG500 28P. Now I want add a second switch,  in stack.I'm not able to find a info if  I can create a stack with the port S1 e S2 with a "normal" ethernet copper cable,  or if I have to use mandatory a Gbic / fiber ...

Buenos días Tengo un problema con el switch SG200-24 cuando configuro mi troncal y utilizo un cable UTP de unos 20 mts. aproximadamente no funciona la configuración, pero si utlilizo un cable de unos 3 mts. no tengo ningun tipo de problema y la confi...

HiI need to implement VLANS across 3 SF-300 switches. We need VLANS to go across the switches. That is we can assign 3 VLANS to the different switches and they would be seen across the 3 switches. The switches are linked through their Giga Ethernet p...

hello ,Since i 've bought it my sg300-10p V01 has always report me a lot of%HAL_config_poe-A-POEFailDetected: POE ERROR(i2c_read_mem failed addr 0x11c6 dev_num 1 val 0x0) was detected: POE is Disabled untill Reset  errors,and take always a very long ...

Hello All, have you any experience with auto deploy many switches from the box? I don't want make manual operations with new switch at all (console connection, ip telnet server, console disconnection, UTP (Ethernet) connection, terminal start, etc.)....

I am trying to install the 1.4.0.88 image and I receive the following error: cisco Status: Copy failed Error Message: Copy: SW code file is over sized I believe that I also need to upgrade the bootcode but I can't find any documentation on how to do ...

What is the best scenario to tie together (2) sg300-28pp and 5 sg300-10pp?*Have set ip for each and upgraded all to latest firmware.*One switch will be directly connected to VPN/Firewall which is connected to ISP modem.*Need best suggestion for conne...

HiI have a Cisco Catalyst 2960G-24TC-L Switch with i did a reset of by holding down the mode button until it reboored itselfAfter it rebooted i cant access the router anymore, i get "access denied" from both the HTTP interface aswell as when im tryin...

Hello everyone. My company has a SG 300 here and we have access to it through console port but when we try to access through SSH we came across this information: "Connection closed by server: Server reached maximum number of simultaneous connections"...

Hello,  Forgive me if this is basic or obvious in anyway, I appreciate any help I can get.  Plugging in a POE device (ip phone/camera) to the left side ports (1-12, 25-36) will power up the device, giving solid amber/green led's on the port.  At this...