Switches - Small Business

I need to test a new phone system that is running on vlan 120. The problem is my current voice vlan 110 is still in use for my current phone system. How can I assign a different voice vlan for a single port without having it propagate to the rest of ...

We have 802.1x authentication via radius and vlan-id tagging with guest vlan fallback working successfully, but we've noticed that no matter what settings we try for the port, it seems that the switch takes about 20 seconds after the port comes up be...

 dear friend how to configure dhcp server in cisco sg 300 switch ?

Hi everyone, We have Cisco SG-300 switch(Layer 3 mode) which is connected to a RV042 router to provide internet on VLANs.We have Static Routing Table - Destination IP "0.0.0.0" and Next Hop Router IP Address "192.168.1.254" which is the RV042 router....

When I am trying to configure VLANS to have a specific IP address, once I set up the IP Address on just one of the VLANS, the entire switch stops functioning and I have to perform a hard reset on the switch. I am using the GUI interface on the switch...

Hi to All, We have a project(cctv system) in which we are using around 40 cisco SG300-28 and sg300-10p. 10 of those switches will be using MGBLX1 and will connected to a fiber core switch. If we inter-connect those switches using fiber(sfp), what cis...

I did a BOM using ESW-520-48-K9 with SFP MGBSX1 (I need 1000BaseSX).But the configuartion tool said that Unit Price Column: "EOL" indicates item is end of life; N/A indicates item not available in current pricelist

I have two switch: L3 SG500 -52 (firmware 1.4.0.88) and L2 SGE2010(firmware 3.0.2.0) . I create 4 Vlan in all switches : 1 DefaultEnabledEnabled   2PCStaticEnabledEnabled   3SERVERSStaticEnabledEnabled   4PCSECRETStaticEnabledEnabled   5MFUStaticEnab...

I have a SG200-26P which I would like to have three interfaces COMPLETELY segregated from the rest of our network.. I though by using VLANS I could do that.. but the three interfaces I included in the VLAN and still communicating with the rest of the...

Hello,I have a few 10/100 devices connected to our SG200 and all of them are working fine except the Xbox 360's. They are primarily used for video streaming and the audio stutters and video becomes pixelated at times. Also a "network issue" pop-up co...

I was wondering if anyone could give me instructions on how to set up ACS for TACACS+ on a 300 series switch using Authorization? I can get it to work to authenticate, but the authorization doesn't seem to work like a catalyst switch. Thanks in advan...