Switches - Small Business

Hi,I'm using DHCP server on SF300 switches for assigning IPs to guest clients.DHCP lease expiration time is set to 1h, start address is 192.168.1.11 and end address is 192.168.1.20.SF300 switch assigns all 10 IP addresses to different clients until p...

I am trying to configure a network for routing IPv6 on my SG300Main requirements:- The purpose of the network is for a Lab- The use of IPv6 Unique local addresses should be used- Leverage separate IPv6 subnets and vlans(I am aware that broadcasts are...

There seems to be no apparent way to change the Link Local address for an IPv6 interfaceIf I create more than one interface they all appear to have the same Link Local address

Hi,How do I upgrade the bootloader  on a Cisco SG200-50 GigaBit Smart Switch ? Br. Torben Grosen 

HelloI need help, i backuped the configuration of me main switch to .txt file be "Dowloand\Backup Configuration" and i have problem with importing this file to new switch. Can someone write me what should i do if i want to import this file? The switc...

I am trying to add redundant default gateways, but it will only display one as being in the route table   The SG300 is in L3 mode, with the following interfaces #show ip in IP Address I/F I/F Status Type Directed Preced...

Please see attached. Is what I’m trying to do possible with SG500x (as the core) and sg500/300 (access/slave switches)? If so, can I use 4 sfp ports from the sg500x to connect the four access switches and 2 gigabit Ethernet ports to connect the other...

Hello,I am having some serious connectivity issues between the hosts in my LAN.My LAN is based on a Cisco 2901 router and a Cisco SG300-52 port switch.The issue that has been happening is that connections between hosts on the LAN (remote desktop, ext...

Hello Cisco Community! I'm hoping someone out there can confirm my diagnosis. Still a little green when it comes to this kind of thing. IssueIntermittent connectivity to Vlan105 from all other Vlans and slowness between hosts in Vlan105.  DiscoveryST...

I have configured a LACP port-channel between a SG50052 and a Catalyst 3650. I get a lot of CDP messages at SG's console about native VLAN missmatch even though the trunks and port-channels seem up and running at both ends. This is happening for a co...

Hi,I have configured redundant network using two Cisco SG300-28MP 28-port Gigabit Max-PoE Managed Switch through MSTP & it's working fine.I need OID of MSTP status from which I can monitor which Switch is active and which one is in standby mode.Pleas...

I'm sure this is a silly question, but I wasn't able to find a definitive answer elsewhere.If I have two stack cables connected between two SG500-series switches, it my effective link speed between the two devices 2000Mbps in each direction, or does ...

We have two Cisco SG300-10 switches that broke down on us.On one, all ports lights blink rapidly in unison. We've tried resetting it to factory defaults, but to no avail: the switch just keeps blinking. On the other switch, the lights blink about eve...