Switches - Small Business

Hi Folks, I need to change the password for the terminal and for the enable password on my cisco switches following the departure of a member of staff. I already know both passwords so I don't need to recover my switches I just need to reset the pass...

Dear Community/Support: setting up our new series 300-28 in Layer3 Mode with a very basic network setup:LAN: 192.168.0.0/24VOIP Switch: 10.128.0.1 -- attached to GE24__________________________default VLAN1- 192.168.0.254added IPv4 Interface: GE24-10....

I need to provide a RoHS Cert for a SG-300-20 for a pre-sales engagement.  The link on the website says for a SG-300-20 (SWR2016-K9-NA) but displays a cert for RoHS is identified for the -EU version but the associated document EU18337 shows model SG2...

Hello,I got a switch SG200-50P. From time to time it makes a lot of noise with the fan, just like an airplane motor, it's really anoying.Is there a way to limit it?

Hi.  I'm just starting to learn about some of the managed switch features/concepts.  We're considering purchasing an SF200-24 switch as we have the need for VLAN support.  Currently we are using a very old router (SonicWall TZ-170).  Will we need any...

We use the SG200-50P and just purchased the SG300-52MP.  I have 7 VLANs setup on the SG200-50P and use both VOIP and Data on the network.  What is the best way to connect the SG300-52MP to the SG200-50P switch?  I would like both switches to be on th...

I followed this guide. http://sbkb.cisco.com/CiscoSB/GetArticle.aspx?docid=caae365b755f46f5989177cb68216304_Link_Aggregation_on_Cisco_Series_Managed_Switches.xml&pid=2&converted=0 and linked ports 2 and 26 on both switches. Outside IT staff seems to ...

Hello, I had a very strange occurrence recently which I suspect has corrupted my Cisco SG500-28P switch.A couple days ago the power went out and the switch turned off, shortly after the power returned... but the switch did not power back on. I pulled...

Hello everybody, i'm jonathan.I’ll explain my issue.We have (this is an example) two subnets, 10.0.0.X & 10.0.15.X which can access everything on our network. And the subnets 10.0.1.X to 10.0.14.X which can only access internet and absolutely not the...

Hi just looking for a little clarificationWe use a mix of SF300 SG300 Non PoE & PoE [including MP & MPP], we also have a couple of SG500s Non PoE & PoEWhat is the best practise for loading config files on these switches - and are the config files cro...

Hi everyone,Is it normal that on the SG200-26, latest firmware 1.3.7.18, some menu are doing absolutly nothing?These menus, provide no options, just a plain blue interface :Administration - Discovery LLDP - all of themPort Management - Green Ethernet...