Switches - Small Business

Hello,I want to setup VLAN to separate attached devices (will use a VLAN capabel WLAN accesspoint).I am looking at the Cisco Small business products.Like this: SG200-08PThis is my goal:3 VLAN's: Internal, External, GuestDevices connected to Internal ...

Hello, does SG500 support LAG with ports on multiple switches? I would like to stack a pair of SG500 and connect each client to both using LACP in order to achieve switch redundancy.

Hi there,There seems to be a problem with some switches that it doesn't allow us to change the untagged VLAN in the smartport macro.This causes a problem: if we change it manually when we apply the smartport it works fine but if the switch reboots th...

Hi all,I have recently received a SG200-26P poe switch to potentially upgrade the office switch.So on first boot - it went through its post, got a solid green light.I then connected my PC to the first port to try and configure it via the web interfac...

Probably more pressing information than what is below, but if I have a SG300 in layer 3 mode, can it handle multiple DHCP scopes using one nic out of the server, or do I need to add a router.            I have two SG300's that I'm working with and I ...

I am trying to get multicast across VLANs working on my SG500 and since it doesn't have PIM, I think the Multicast-TV option can work.However, now my clients are getting switched to the Multicast-TV VLAN instead of the regular VLAN they are assigned....

I recently bought a Cisco SF200. I'm unfamiliar with the whole vlan topic. We have 2 departments. I want to create 2 vlans, that share one internet connection. We have a standard Cisco Cable Modem.Can someone please advise on how to get this up and r...

HiWe have recently changed our access switched to Cisco Small Business SG-300 52p on which is working firmware SW version    1.3.5.58We found out a very annoying problem on Port-channel and default vlan topic.Our switch have a default vlan diffrent t...

By default the SG300-52P switch (300 Series Managed Switch) creates a Dynamic Address for any computer attached to it. I would like the switch to accept connections only from devices whose MAC address are "registered" in the device. I see that it is ...

  Investigating a slow transmission issue at a site with 3 switches.   A 200 Series Switch and a C2960G hang off the SG300-10 which is currently running in layer 3 mode with qos enabled but not routing.   Currently no VoIP and all classification and ...

Hi All,I need SNMP MIB files for Cisco SF 300-48 48-Port 10/100 Managed Switch.I have gone through cisco site but not able to get it.Can anyone please provide me.I have stuck with this.ThanksRam

Tomorrow I will be setting up a simple router and switch configuration in a small office.  The network will be a flat network with no seperate vlan for voice and data.  We will have Cisco 7961 Cisco phones connecting back to our main office via a sit...

i cannot assign static ip address to lag or vlan, web browser always lose connectivityin ipv 4 configuration i was delete the dhcp configuration, but still the sameplease explain step by step, because i'm a newbie. and sorry for my bad english