Switches - Small Business

I have a SG300-28 and would like to configure through CLI not menu. How do I get to Cli from Menu?  I am running Boot version 1.0.0.4 and SW version 1.0.0.27, Do I need to upgrade both boot and SW or Just SW?

Hello,I have problem with simple VLAN:I change switch to layer 3 system mode.To port 1 I have connected router. I create 2 vlans:VLAN settings: vlan id 2    and vlan id  4I go to Port VLAN Membership and I join vlan to GE2 2T, GE3 2T, GE4 4T, GE5 4T ...

Hi there,We have several SG300 series switches in our LAN. Yesterday, I was patching one to the actual firmware. When booting it up, I found a feature in the telnet session that promises me to set a stacking ID.I didn't find any info in the cli manua...

Hi,I have a couple of SG500X Switches which need to be configured and I wanted to do this with a central managed tool to have an uncomplicated way to configure the switches.I already found Cisco Configuration Assistant, which supports the 200 and 300...

how to config web authen on new firmware 1.3.5 of 300 and 500 series

Hello,The company I work for has some Cisco hardware in the plant and, as our team has no expertise on configuring Cisco switches I hope you can help me and my team to get this problem solved. I will make a brief comment on what is going wrong here:I...

Dear support,Can Cisco 500 series switches deliver 24V on the access port for POE operation?Best Regards

I want to install a SonicPoint on an existing SRW224G4P switch.  Sonicwall architecture uses VLAN to support multiple SSID on SonicPoint.  Sonicwall interface X0 attached to port e12 on the switch, and the Sonicpoint on e24, which is PoE enabled.  In...

                   I would like to connect a Sonicpoint to an installed Cisco SRW224G4P switch.  Sonicpoints support multiple SSIDs, each on a VLAN.  One VLAN is Corporate (20) another Guest (30).  Guest pointing outward to internet only via firewall...

Hello my name is chris and i have a slm2048 switch that my boss has forgot the password to and he need to me to get on to it's gui. I have tries to hold down the reset switch for at least 10 seconds and it will not reset to factory defaults. For some...

We added a SLM2048 gigabit swtich to our office recently.  It works, devices connected to it are able to access the LAN and internet.  However, I can't access the web interface for some reason.  When I enter the default IP address (192.168.1.254) in ...

Hi all,I have read through various Cisco documents and tried various configurations and i have been unsuccessfulHere is the network layoutCisco SG300-10 in Layer 3 mode, managing all VLANS created and inter-vlan traffic is working finePorts 1-4 are i...

Hello,i have installed SG300-10SFP switch in one customer site, port g1-g9 is for customers and g10 for uplink to Metropolitan networkafter installation, all working fine, in port g10 i have installed SFP CWDM with DDI (diagnostics) all data like Tem...

Hi all,We  have an existing GPRS modems to tranfer data between 2 different sites,  This connection is a little bit slow at no more than about 114kbps, the  idea is to add a 3G modem, so the solution will be based on a dual communication lines which ...