Switches - Small Business

Can't seem to get DHCP to function properly with my SF302-08 in the network path. Thesetup looks as follows:wall-jack                <->  Linksys 8 port switch                                                    <->  SF302-08                          ...

Copying the configuration from my SG300 switches to my Linux management machine takes a surprising amount of time. Example:sw1#copy startup-config scp://mgmtsrv/sw1.cfg21-Oct-2013 10:35:29 %COPY-I-FILECPY: Files Copy - source URL flash://startup-conf...

Hi, Please forgive any ignorances I display here. I am not a IP expert at all. I have multiple audio hardware that I am networking togther which specifically gives me a MAC address that needs "Layer 2 Multicast Filtering" on one of my switches ports....

Hi,I wonder if the SG300 there is a "MIB" which allows for the cumulative traffic on all interfaces for a particular vlan.I know we have this information in Catalyst switches in the SMON MIB but I can not find the equivalent in the SG300Thanks

HiI have 5 clusters in a data center running with VMware dv switch and standard switches .All are E.P licences. I am planning to create nexus 1000v switch and migrate all of the cluster networks to Nexus 1000v switch . since Nexus 1000v is most advan...

I have the wonderous task of remotely configuring a few SG200 small business switches.I need to create a vlan and move a few ports into that vlan, doesn't sound too difficult. I have created the vlans but when I go to add the ports into the vlan the ...

Hi,I have two NAS. Each one from a different manufacturer, QNAP and Synology.The two NAS support LACP IEEE802.3ad but in this way QNAP loses 40% of the packets and Synology not work.With a Cisco Calatyst 3750 both NAS I work well. Do I have to do som...

Hi everyone,on my network there are 4 Cisco SG300-10 switches connected to each other via a single uplink port. On one of these switches there is a LAG 802.3ad port configured that provides network access for a QNAP NAS. So far so good.My problem is ...

Hi need someone to confirm my findings for this problem.So I've got a SG300-10 10-Port Gigabit Managed Switch (Firmware 1.3.0.62 ) in L3 Mode and QoS Mode in Advanced.So if I make MAC-Based ACL without entering a Ethertype and make IPv4-Based ACL or/...

good morning, nice to saludoarles, I write because I have a problem with a model SG300-28p switch, I explain:had run the company normally switch until one day we were completely without a net, the teams showed "Network cable unplugged" apparently the...