Switches - Small Business

I use this oid to gather mac address: .1.3.6.1.2.1.17.4.3.1.1This has worked on all of our cisco switches (3560,SG300, etc...). When an SG300-20 was updated to 1.2.7.76 the oid no longer exist.snmpwalk -c public -v 2c switch .1.3.6.1.2.1.17.4.3.1.1is...

Hi all,Does anyone know Cisco Small Business 300 Series Managed Switch support dhcp server service? I have a SF300-24P but i cant see that option to configure dhcp server. If any 300 series switch supports dhcp server then please let me know.Kind Reg...

Has anyone here tried to  mix a Catalyst switch (say, a 3500 or 2950) with a Cisco SG200-26?I've got 4 VLANs setup on a 3500: 1 (default), 10, 20, and 30 I've tried to connect a trunk port (GBIC) out of a 3500, into a SG200,  with the hopes of being ...

Please hel, with this one, for some reason I cannot access my SLM 2024 switch via the default web ip address over the browser. Any suggestions ?

Hi,i have a question about the max number of sfp ports available on the SG500X-24 Switch. I need to configure a Stack with 2 SG500X-24 units: can i use 5G ports and have 4 SFP as network ports. In the quick start guide i read that i can use i couple ...

helloi'm using cisco sg 200 switches(24port ,48 port with 2 GBIC (rj-45 port and spf port) on each). in a small office network.i've attached the diagram.please answer the below queries.1)what should be the default gateway for both switches(coz im not...

Hi,I have an SG300-10P but it doesn't seem to working as expected, so I need some help getting the configuraiton correct. I have a workstation on a vlan (998) but it can't ping a host on the internet (8.8.8.8) but from the switch I can ping 8.8.8.8. ...

I have just set up an SG300 with protected ports so that different ports can not see the traffic on other ports. Now I am being asked to restrict specific ports to using only specific ip addresses. Is this possible with this switch?Each port will nee...

I am trying to leverage a couple of SG200 for a small office area.    It will be downstream from a 2960 layer 2 switch, connected to a trunk enabled port on the 2960.   The topology looks like this:/PC DESKTOP/====/IPPHONE (7962)/======/SG200/======/...

Attached is a current network diagram.  The wireless point to point links between the switches are 5.8Ghz radio's.  All switches are Cisco Small Business 200 24-port POE.I first turned up switch A, B and C but only had wireless links A and B connecte...