Switches - Small Business

I am somewhat new to this level of networking and have run into a problem that I cannot seem to overcome...I have an SG 300 switch that I had configured, and had working just fine, at my old residence using a DSL line. Since moving, I have changed ov...

Hi everyone, my switch cisco small business SG200-26G  in modality link aggregation LACP the Wake On Line doesn't work !! (WOL work only in link aggregation non LACP..) I already upgrade the latest firmware but not resolved.. Do you know how to point...

My customer has a intermittent connection loss issue with SLM224G2.In the network, there're NMS system(VLAN10) and users(VLAN20).After IP MGMT SYSTEM(Netclient) is attached, ICMP from NMS system to mgmt IP of SLM224G2 sometimes failed.But the users c...

Hi,I have to configure multiple vlans served with a unique DCHP server . As first step, I just will The DHCP server to serve 2 vlans. The following is the hardware and configuration that I implemented :Router (RV016 10/100 16-Port VPN Router) as gate...

Hello,We have a Cisco SF 300-08 here at work that cannot be used. The system lights are green and flashing. I looked into the manual and pressed the reset button for more than 10 seconds for a factory reset. The port lights lit up momentarily and the...

Hello All,I saw a post in routerdiscussions.com that was close to what I need to do.  But this site seems a better placeto ask a question.We need to install a second switch (SF300-24P) to an existing network with an SF300 48P and an ASA5500 for gatew...

Hello:its been a while, previously I got some great help here with setting up a bunch of SF302-8P switches for use with Avaya phones in this thread.https://supportforums.cisco.com/message/3585473#3585473One of the things we found with the SF302-8P sw...

Datasheet says there can only have 200 ports per stack, and maximun 4 sw can be stacked.Which was the limitation?Can I stack 8 24-port switches (192 port total)Thanks               

Hello there,I'm wondering if that make sense to stack 2xSGE2000 and having a double connection on my server with bonding 802.3ad :SW1 --------------- BOND0/ETH0   |    |   |Stack on g24   |SW2 --------------- BOND0/ETH1Thank you in advance for your o...

I just recently purchased an SG300 10 port switch. After reading through many of the threads here, I was finally able to get the different VLANs to route properly. However, I'm having a unique issue that I'm not sure if it's related to the switch or ...

I'm new to managed networking.  So I'm having trouble understanding how to set up my switches properly.  I have a closed network with about 20 switches and 2 IDF's.  No router, and no internet.  I have a SLM 2024 in want to have 4 ports set up with a...

I am about to pull what hair I have left out! I have configured many a Cisco switch with VLANs and for some reason, once cell must not be firing today...I have a client who needs a simple wireless infrastrucrure: one WLAN for company traffic and one ...

I have connected 2 SG500x switches using an SFP-H10GB-CU1M SFP+ Copper Cable module.  Since the port shows as a 10G port, I would expect the speed to show as 10G as well.  However, it shows as "Unknown".  This doesn't leave me with confidence that it...

Hi,I am using a Cisco SRP527W router for our small business. As this device only has 4 LAN ports I want to add another switch so as our business grows I can add more PCs and VoIP phones. I would like to use a Cisco SF300-24 switch and before I purcha...