Switches - Small Business

I recently started upgrading our small business line to image 1.2.5.70. This includes an SG300-20 and five SG300-28P 's.  The first thing I noticed is that the switch applies port power well before the switch has finished booting and is forwarding fr...

I have 3 different sg200-26 switches, one of which is acting like a hub

I have a situation where I have ethernet traffic from two separate networks/ip subnets (Subnet A and Subnet B) on a single ethernet connection.  I have the need to separate the traffic into two separate networks and two isolated broadcast domains.  I...

Hello everyone, I am the Systems Admin at LDM Media and am trying to get some support for one of the SRW224G4 managed switches we have in our rack.The issue is as follows:any endpoint connected to the switch is assigned an IP address in the range of ...

Hi i am trying to get a SG300 work as a router between VLAN'sSo fare without any lock :-(Test setup one SG300 switch and 2 PC's  Ping works from host to VLAN IP's, but not from host A to host B Anyone got a idear on where i got it wrong BestJohnc1882...

HiCan anyone help me with this problem.I recently acquired a used SRW2016 in perfect working order (I checked it) and then made the mistake of trying to update the software image. Since then I cannot get any image to boot and cannot install a new one...

I have a SG300-28P switch. I just read in the Administration Guide that, when in Layer 3 mode, the switch doesn't support MAC-based VLAN or Dynamic VLAN Assignment.So, in order to assign a client to a VLAN based on their MAC or based on the response ...

We have a customer who we sent to Cisco to replace some aging Dell switches. They purchased 5 SG300-52’s for 2 different networks. Their production LAN has 2 “live” switches and 1 spare. The 2nd, a development LAN has 1 switch and 1 spare. Their prim...

Hi all,Just a quick question to know if there is a way to access the usual command line interface instead of using the GUI or Telnet/SSH interfaces on the Cisco Small Business SFE2010P switch? Note that the console port is not working at the moment.....

I have a situation where i am installing SGE2000Ps to replace my old switches and configuring VLANS. The time clock will not communicate across the VLANS. If I unplug the network cable and plug it back in I will get two successful pings. If i use a P...