Switches - Small Business

I configured a new SG-200-08 with a static IP. I tried to save the configuration as the startup configuration. After 10 minutes, I restarted the switch. It didn't boot with the new configuration, and returned to the default .254 and default pw. Now I...

According to the documentation, the Switches SFE2010P and SGE2010P have a maximun total power output of 360W. Using only SPA500 series IP Phones that have 10W maximun input, how many SPA500 IP Phones could be connected safely to this switches? 36 ? o...

I am looking for a Best Practices or a few places to pay attention to in the Cisco ESW-520-48P switch I have. My VoIP solution is RingCentral, and while they are Cisco phones, I've been hestitant to setup VLANs etc. the way I am used to. Plus setting...

Hi all,I have a Cisco SG300 switch on which trunks are configured. I have a server which sits on the switch via a trunk link of four network cables (4 Gbps total)on which LACP is enabled. I'm having trouble connecting to the server using VNC from a c...

We've performed the cutover from our old NEC Digial phone system to the New Avaya VOIP system, and are utilizing Plantronixs headseats and brand new HSI0312 headset cables connected to the Avaya Phones.  We have 30 of these switches deployed at vario...

Hello and thanks in advance for your help.I set an SG300 switche in layer 3 mode with 3 vlans.I need to give IPs to a whole vlan machines. Do the switch have a DHCP server per vlan? Can someine help me to configure this?thanks!

Hi,Does anybody know if STP Root Guard feature is supportted on SMB 300 switches? I was not able to find anything related to Root Guard on the administration guide. Thanks in advance,Burcu

I can't for the life of me get a mac acl to be accepted. I keep getting the"MIB index is out of range...index must be bigger then 0 and Existing ifindex"This error message is meaningless to me and gives No clue as to what the realissue is. I have fil...

Hi,I have a SG300-10 in layer 3 mode attached to a Fortinet firewall (FG). The Fortinet syslog is reporting repeated traffic violations with the following info:src: << IP of the interface that the SG is attached to >>dst: << IP of system connected to...

Hello,I was told I need either multiple DHCP server or DHCP server with multiple NIC or the DHCP server is capable to handle 802.1q to make the switch works with DHCP relay.Is that right?Thanks,

如题，在WEB界面用TFTP升级SRW2xxG4_FW_1.2.3.0.ros，重启后，交换机启动不了，超级终端链接后也没有显示。还可以恢复交换机不？thanks.

How do I make the following work with Cisco 302-08G ??I would like to sniff (using wireshark) all traffic in my office. I have a 4-port Cisco wireless/wired router that allows for a guest account. I also have Cisco SF302-08 that I bought so I could u...

Have tried to no avail connecting with a serial cable and Dell D600 to reach the console on this switch.Used the following settings on COM 1 & COM 3 in HyperTerminal:     * Bits per second: 38400    * Data bits: 8    * Parity: None    * Stop bits: 1 ...