Switches - Small Business

We are using a SD2005 unmanaged switch and the requirement has changed to require DoD Information Assurance to be applied.I have not found any user's guide to allow any configuration of the SD 2005.Is configuration possible on an unmanaged switch and...

Hello,I have problem with Port Security on ESW 520, when it is configured with violation action shut down, and violation happens, i could not recover the interface until switch is reloaded. The Software Version ins 2.1.21.

Hey Guys,I have a Cisco Calayst C3560G core switch with 4 x SGE2010P Switches which are invidually linked/trunked via 2x CAT6 Cables for each SGE switch so im not stacking them. First problem is i cant seem to trunk/bond the 2 cables to the SGE LAGs ...

I bought a Cisco sg 300-28 28-port gigabit managed switch and it appears to have lost all software. I connected with a console cable and it just keeps rebooting. It does not stop at the prompt so I cant update the firmware. It was working alright bef...

Greetings.I have an SG-300-IP Gig POE switch installed and connected to a Cisco 1921 router - in turn conected to DSL.I have the router running DHCP.  Hosts can connect - get and IP and relevant DNS servers - can ping Internetby name and number - but...

Hi,I've started having problems with one of my ESW520-8P-K9 recently. I can't access its web interface anymore. I've done a factory reset on it but it is still the same.After doing some tests trying to pinpoint the problem, I've find out that when tr...

Hi!I have no previous Cisco switch experience. I just received a brand new SG200-08 switch. It replaces a small blue Trendnet 5 port switch. I configured the SG200-08 with a static IP address which is on the same subnet as all our wired devices, then...

What is the switch latency for a SG302-8P for L2 and L3 packets?thanks,Carlos

Hi Everyone, first question i've posted, i'll try and give as much information as possible, i'm an extremely quick learner as well and have been around networking for nearly 20 years but this is my first outing into the medium sized VoIP deployment w...

Hi Guys,I am using around 5 sg300's with a lot of Crestron AV kit / touchscreens. About once every couple of months the touchscreens all stop responding. We have found that a reboot of the Cisco switch attached to the touchscreens brings everything b...

I work for a small business and we have a couple computers that we want to share a ethernet enabled copier/printer with, but for security reasons want to block those computers from internet access.  How would one go about allowing that?Thanks in adva...

Dear Cisco,Can you please explain what is the (best) procedure to configure Auto Voice VLAN???Scenario:Please allow me to explain what I am trying to achieve and the problem I encounter. First of all, I know how to configure Auto Voice VLAN. But I go...

Hi,I am using the CISCO SG300-28 with firmware version 1.0.0.27. I enabled RADIUS authentication and accounting. Authentication is working but there are no accounting requests/replys (Accounting on, accounting off, accoun ting start, accounting stop)...

For having 3 settopboxes for iptv I have setup vlan 3 for iptv.IGMP snooping is enabled for vlan 3 with the default settings and port 5 (incoming iptv) is enabled as IGMP Mrouter.In the multicast forwarding table vlan 3 is set to filter unregistered....