Switches - Small Business

Hello,Anyone else have problems with OS X and the SG200-26 switch?I've connected two different macs to it and tried to load the default url.  Nothing loads and it time out.I've had this switch working before, but I've had to plug the macs into a 4 po...

HelloI used LACP on port 49 and 50.After upgrade firmware from 1.0.0.19 to 1.1.2.0 my LAG1 stay down...all port member stay down, port link is up but LAG stay down...I testtu delete and reconfigure LAG1 but nothing work...

Hi,When I came back home today I saw that my SG200-08 switch did not look fine.Basically, the system LED of the switch keeps blinking and end devices connected just don't have any network.I tried to reset the switch with the "reset" button (with a pa...

Hi!I hope this is a simple question ;-) .Can someone explain the difference between "fobidden" and "excluded" in vlan membership configuration? Please provide more details than the admin guide.Is there a difference if port is configured as trunk at a...

Dear Cisco staff,     we confuse about datasheet 300/200 series and the real product why don't correct ?300 serieshttp://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps10898/data_sheet_c78-610061.html200 serieshttp://www.cisco.com/en/US/prod/c...

What i am trying to do.I have a network that I would like to have two VLANs.One for VOIP phones and one for the rest of the network.  I would also like the VLANs to be able to communiacte to eachother.Also I would like our Windows DHCP server to be a...

SGE or SFE model can use LAG cross stack with 802.3ad ??comment : why this community so quit nobody answer ...

OK, this is a complicated setup, and myself and my fellow IT staff have been beating our heads on a wall trying to get this to work, at this point we do not even know if we have this configured right, so any input on this would be most appreciated.We...

Im curios to see if anyone is still having the MAC address issue rebooting the switch every 50 days witoh the latest version 1.1.2? Im getting ready to deploy these for a faternity at a local college.

HiI am trouble shooting a SF 200-48P and I am a bit lost without a CLI not used to the GUI. What I need to know is how to add the IP address helper command to the switch?I have a number of IP phones which are not getting an IP address from DHCP (PCs ...

How i can see mac-address table on sge2000? I'm need to see mac-address on ports in lcli interface.Thanks.

Hi everybody,Got since a few weeks, a SRW224G4 on my workbench, which leaves us completely puzzled.Perhaps somebody has had a similar problem or is able to contribute to a resolution of the problem.The end-user has already a replacement switch so the...

Picked up an 8 port SF302 on the fly to replace a 2960 that has failed. Attempting to config for use with DATA and VOICE vlans. Device port G1 is connected to 0/1 on a 2911, which has 2 sub-interfaces- 1 each for voice and data. Cannot get switch to ...

I have a SRW248G4P switch that isn't responding to either the console or webview.  When I power on the power lite stays yellow.  Is it completing the bootup?Anyone have experience with this symptom and perhaps a solution?Thanks in advance,Robert Jone...

In our scenario setup is following:Trunk from 3500 going into SF300-8 #1 QNQTrunk from SF300-8 #1 going into trunk SF300-8 #2QNQ from SF300-08#2 going into Trunk SF300-24All Vlans from Network 1 seem to be communicating properly between the 3550 and ...