Switches - Small Business

Hey guys!I own a Sg200-08 and everytime when I transfer a lot of data via the switch it crashs when around of 100GB. Crash means it will stop working until I disconect power and reconect again.I've checked it back with a Netgear 8port device, this wo...

hi all we have a production network that uses five SG300 switches that functions brilliantly most of the time. four of our switches run in layer 2 mode and the last switch runs in layer 3 as it is used to route our 7 vlans as well as routing traffic ...

Hi,SG300-10   mode:layer 3dns server:192.168.2.11vlan1    192.168.2.0       ip:192.168.2.254    0.0.0.0 next hop 192.168.2.3vlan2     192.168.50.0     ip:192.168.50.254 dns server table:192.168.2.11 (active)Router(192.168.2.3)    dst.address 192.168....

We have a customer who is replacing older Dell switches with Cisco SG300-52s.  On one of the SG's they'll need 6 ports reserved on a VLAN for public Internet IPs (the 100Base-T uplink to the data center's Cisco switch as well as multiple Cisco ASA's ...

I have been using SRW series to setup VOIP phones in a flat network without creating a separate vLan. This works well because i can add and remove up to 48 port into port mirroring. Unfortunately the new models only support 8 port mirroring. This is ...

Scenario:I have a network that consists of the following:Internet -> Comcast modem -> Linksys RVS4000 router -> 2 x Linksys SRW2048 switches -> LAN connected devices.IssueOne of the switches is really slow at handing traffic regardless of how many po...

I am trying to setup up an LAG with LACP between the switch and a Synology DS1511+. Every time I enable LACP on the LAG I cannot get the ports to become Active Members. Any help would be much appreciated! Thank you!

HiBrand new SG300-20, every now and then on console12-Nov-2011 23:35:33 :%HAL_config_phy-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media (Unknown) on port gi19.12-Nov-2011 23:35:33 :%HAL_config_phy-I-CHNGCOMBOMEDIA: Media changed fro...

I'm completely new to VLANs, and I have a client who has a SG300-20 switch. This location is basically a shared office space with individual offices inside a large building. Each office has network ports that lead back to a patch panel, which then is...

HiA customer of mine is having serious problems with several ESW-500 switches.He started a discussion under Netpro, but haven't received any answers. This might be the right group?He wrote:I have two new esw-540 switches (one 48 port  and one 8 port)...

My customer has an SR2016 device which has never really worked consistantly.  They were assured that they would always be able to upgrade it to a comparable Cisco unit, if they wanted to.  When I told them that the program appears to have ended they ...

Originally, my  client had SG300-28 (purchased by mistake) instead of SG300-28p. I had  configured SG300-28 from CLI and CCA (CCA is a requirement for the Small  Business Pro department to support the voice solution). I then tftp'ed  the config to my...