Switches - Small Business

I buyed a new unit of SGE2000. Thirst I changed firmware to newest one (3.0.0.18) so I do not know what firmware was installed before.The problem is that it is not posssible to change Ingress Rate Limit to value lower than 3500...Hardware Version00.0...

Title says it all....How do you enable jumbo frames on an SRW2008?The data sheet says it supports jumbo frames, but the manual does not say how to enable, and I did not find it in the Web GUI.It just occured to me (light dawns on marblehead) - perhap...

Hi Community,Hoping someone has run into this before.. I've setup a new SGE2000P switch at our offices, configured some of the settings (IPv4 settings, usernames, turn off stacking, etc) and confirmed we're running the most up to date SW (3.0.0.18).....

I have a Linksys SRW224G4. Two PVE groups are in use. However I can't change which PVE group a port is assigned to. The option to change the group is there but ghosted out and can't be selected.I downloaded the user manual but it describes a web inte...

Hi all,Is it possible to connect the SRW2016 to cisco catalyst 3750?The vlan ip and ACL will be in 3750 while the vlan connection will be on the SRW2016.My problem is that I can not ping the other vlan even if I allowed it on the ACL which is located...

I am using the Cisco MGBT1 SFP Transceiver in an SFP Module Interface on a Xilinx ML555 development board.  I need to configure the MAC that I am using to talk to the MGBT1, but don’t know what PHY interface the MGBT1 supports.  Does it use SGMII, RG...

Sorry this may be posted in the wrong thread though "Switches"  appears in the archive section which I don't know why.I  have a SRW2016 switch that I've been using for a year, recently I  changed my password to somehting else which contained special ...

Hi,I need help with password recovery on SRW224G4P. I couldn't get into the MENU by press ESC to interrupt the normal boot process. I tried many many times, no luck at all.Below is what I see during boot up process:Loading Diagnostic Image File : SRW...

hi to all,I'm new here, but i have a problem in configuring the Cisco SRW2016.Is there a way i can configure it through Command Line Interface?Because it's hard for me to configure VLAN and ACL through its WEB management.Also i'm familiar in using CL...

I would like to  receive help over two things here-1. Discovery  of IP cameras fails through this switch (default settings) for Bonjour protocol - a protocol  developed by Apple for device discovery on network. My devices are IP cameras and are to be...

Do they support it?

I just purchased this SRW248G4P switch, powered it up and initially I was able to get into the console port and perform initial configurations.  I connected another switch to one of the Gigabit ports and performed my configuration changes via the web...

I got a used Linksys SRW248G4 from a friend of a friend. I am trying to get into the administration panel and the password seems to be changed from the default. I also can't seem to get into the console (Windows 7 x64, keyspan USA-17HS, putty, 38400,...

The AC power adapter for one of my SRW208P POE switches was lost and I need a replacement. Can someone please advise how I can purchase a replacement AC adapter? Thanks.

Hi Guy,               I have connect Cisco Aironet 1130AG at port# 1 and Avaya 1360 (IP phone) at port# 2.After I switch power core, both PoE ports not up but all of non-PoE ports can up without problem.