CBS250 - ACL works only until device reboots

[Hubsi-Smith]

Hello,

the Cisco CBS250 series is a plague.

Now, I have anther problem that I couldn´t solve.

I have a working output ACL assigned to a port where a camera is connected. Works so far good, until I reboot the camera.

The whole traffic is blocked by the switch until I remove my ACL and re-assign it.

I can´t explain why this happen? This behavior is senseless

[marce1000]

  - Check firmware version , use latest - if applicable.

 M.

[Hubsi-Smith]

There is no difference between 3.0.0.69 and 3.1.1.7 (latest).

Same configuration is working flawless with a C1000. Something is different on the CBS250 series.

[Hubsi-Smith]

I swapped the firmware 2 times and now all works like expected!

These kind of problems costs me a lot of my lifetime...

But in future we will keep off our hands from this serie and move back to Cisco Catalyst.

 @marce1000, thank you for your help. :top: