02-24-2020 09:34 PM
Hi,
Can someone pls share their knowledge or experience in configuring sntp server for sg220.
I have anabe sntp server then added sntp server (internet) name as
sa.pool.ntp.org
Is it correct ?
02-25-2020 02:37 AM - edited 02-25-2020 02:37 AM
thats valid NTP server, check is that your region and near by to your network? make sure your switch able to resolve the DNS names.
02-25-2020 12:05 PM
Hi , the manual time set is getting reset whenever i reboot of power off the switch.
I am saving config , even then time date resetting
02-25-2020 02:20 PM
once save the config, did you go back and see the config is saved as per your change.
check here for last steps to save the config.
10-22-2020 03:00 AM
Hi Balaji,
You were right that as DNS not configured correctly the NAT website could not be resolved.
I change it to IP address and SNTP started working.
Kindly advise about DNS, what should I configure so as web names can be resolved. What should I enter in domain name system. There is no dedicated dns server, so shall I point 8.8.8.8
10-22-2020 05:46 AM
if you do not have any DNS Server - i use google DNS 8.8.8.8 or 8.8.8.4.4 to work.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: