Cisco SG300 - 28P - Port Security Question.

[Parth Maniar]

Greeting's, I would like to enable port security on a Cisco SG300 28P PoE Switch. I would like to know how this can be done in cases where port's are further connected to 8-port desktop switches and in cases where computers are directly connected to the switch.

Thanking you in anticipation,

Parth.

[Tilman Schmidt · Accepted solution]

This is described in detail in section "Configuring Port Security" on pages 326 to 329 of the Cisco Small Business 300 Series Managed Switch Administration Guide document.

The difference between a port serving a desktop switch and one directly serving an endpoint is just the number of MAC addresses you'll want to allow.

Do you have any specific questions?

[Tom Watts · Accepted solution]

Here's 2 documents how to configure port security for dynamic and static.

https://supportforums.cisco.com/docs/DOC-27753

https://supportforums.cisco.com/docs/DOC-27720

-Tom
Please mark answered for helpful posts

[Parth Maniar]

Thank you to both of you. I'm sorry for the spoon feeding i required. I'm sorry and shameful that I did not consult the guide first

[varun_gautam]

Well i small exp. sharing here ..

i would not put a broadcast  control cap on the very port where the 8 port switch is inteneded to be connected .

and ya never be sorry for learning ,its a life process

cheers!!!