04-02-2020 08:35 AM
Dear all,
In order to get more control on my physical ports, I'm starting to try out 802.1x with a NPS server.
I followed instructions from here https://www.youtube.com/watch?v=NIzxpHNtr7I
(Of course, not the ISE part)
I've setup:
- the NPS server policy & radius client
- the radius settings on switch
- one port with auto
- one client with group policy
When I connect the port on client, I get only this :
%STP-W-PORTSTATUS: gi1/1/3: STP status Forwarding
But on NPS, nothing from the switch IP (wireless works fine since years)
Any idea where I should start from ? Thx ! :-)
Solved! Go to Solution.
04-02-2020 10:33 AM - edited 04-02-2020 10:33 AM
Never mind, everything was right in the configuration (GPO, switch, etc...).
The ONLY missing part was to put the Wired AutoConfig service in automatic mode in Windows... ;-)
04-02-2020 10:33 AM - edited 04-02-2020 10:33 AM
Never mind, everything was right in the configuration (GPO, switch, etc...).
The ONLY missing part was to put the Wired AutoConfig service in automatic mode in Windows... ;-)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide