cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
971
Views
0
Helpful
2
Replies

Cisco sge2010p LAG to HP procurve switch

krzysztofsyguda
Beginner
Beginner

Hi;

I have configured  stack with 2 sge2010p switches. I want to connect this stack to the HP procurve switch using port agregation (LAG) technique.

I want to use one ge port on each sge switch.

How to configure it? Will it work witch port agregation on procurve?

Should I enable STP on LAG interface?

2 REPLIES 2

David Carr
Frequent Contributor
Frequent Contributor

Krzysztof,

In theory, this should work, since you have the sge2010's in a stack it should work.  I have not tested this personally.  Of course if it don't work, you can still  have the redundency of having 1 port from each switch going to the procurve with rstp enabled.

nimusell
Beginner
Beginner

Dear Krzysztof,

Thank you for participating in the Small Business support community. My name is Nico Muselle from Cisco Sofia SBSC.

As for your first question, yes, ports from 2 different switches in stacking mode can be added to the same LAG.

For STP settings, as the switch configures the LAG as being one port, you have to configure these settings on the LAG, not on the separate ports.

Hope this helped,

Best regards,

Nico Muselle

Sr. Network Engineer - CCNA

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: