09-06-2010 01:54 AM
Is there a way to automatically change the port state (SLM 2008 switch) from enabled/100MB/1000MB to the disabled state?
The setting change must occur on certain times of the day.
Or, if possible, based on port statistics (number of Mbytes sent/received).
For example by running a script on the switch itself, or on a device connected to the switch (PC)?
09-06-2010 08:17 AM
on a PC
you might want to look into an SNMP management system which can be scripted
or use Radius authentication to de-authorize the port at specific times
09-06-2010 11:16 PM
Does the SLM2008 support SNMP?
09-07-2010 07:09 AM
sorry, no SNMP
my fault
you need to invest into a fully managed switch, seems the SLM series is too leightweight for that
09-07-2010 08:42 AM
i got confused
The SLMxxxS series has SNMP
the SLMxxxx has no SNMP
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: