There is a backdoor CLI for the SGE/SFE2000/2010 switches. However, the feature is unsupported and not recommended to use. Additionally, if you enable the CLI view on the console, there is not an exit command to go back to the menu driven supported configuration.
To access this configuration you can telnet to the switch (if you enable Telnet under the Bonjour tab) or console the switch. Authenticate as you normally would.
Press ctrl+z at the same time then type LCLI and hit enter. This will toggle the CLI and a 'normal login'.
Please mark answered for helpful posts
Fix SPA500 Series SOS Mode Recovery
The SPA500 Series phone goes to SOS Mode Recovery state when the firmware on the phone is damaged. This is typically caused by abnormal operation such as a power interruption while the ph...
Replace the Default Self-Signed Certificate with a 3rd Party SSL Certificate on the RV34x Series Router
A digital certificate certifies the ownership of a public key by the named subject of the certificate. This allows ...
I was buy brand new router and have connected him to console port but when i need to hit enter after I get message press enter
.I push enter but it says: " authentication error"
I see there is some errors during startup in IOS row 1,5,6,7,8 is little str...
Cisco RV34s comes with pre-defined Microsoft Azure IPSec profile, but seems it's impossible to set up a tunnel with Azure just using default settings.
First, you can find messages in RV34x logs like follow:
charon: 11[NET] rec...
Firmware Downgrade Rules for Cisco Small Business Switches
Cisco Small Business switches sold with the latest release of firmware 2.4.0.x and greater use an updated chipset for Power over Ethernet (PoE) 6920xM version 0x4a0...