cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1625
Views
0
Helpful
2
Replies

failed Firmware-Upgrade on SG350-xxP: Illegal file format :-(

mste972379
Level 1
Level 1

Hello to everyone

I'm currently trying to update the Firmware on three SG350-Switches. One is brand new (SG350-10P) and there I had no problems to step-up to the 2.4.5.71-Firmware.
With the other two devices (SG350-28P and SG350-28MP), after uploading the file I'm constantly receiving the failure "Illegal Software Format".  And I'm using the same file as used for the SG350-10P.....

 

The two switches which don't accept the file have an active & running FW-Version 2.3.5.63.

Anyone who can help?

2 Replies 2

mipopov
Cisco Employee
Cisco Employee

Hello,

Try to upgrade with USB. Maybe you have some network issue.

Copy the image_tesla_hybrid_2.4.5.71_release_cisco_signed.bin to some USB Flash Drive, to the root.

Plug in the USB port and connect to console of the switch with blue console cable:

switchxxxxxx# config 
switchxxxxxx(config)# boot system usb://image_tesla_hybrid_2.4.5.71_release_cisco_signed.bin

Wait for it to upload 

Verify the boot sequence with:

switchxxxxxx# show bootvar

the freshly uploaded 2.4.5.71 should appear as inactive image with the comment: " Active after reboot "

If it is like this, reboot the switch with command:

switchxxxxxx# reload

Hope it helps.

Cheers, 

Mike

Hello Mike

 

Thank you for your help - I connected with SSH, is that ok , too ??

Here the extract of the terminal:

 

***************************************************************

Directory of usb://

Permission File Size Last Modified File Name
---------- --------- -------------------- --------------------------------------
drwx 65536 07-Mar-2019 16:04:16 System Volume Information
-rwx 43487307 28-Feb-2019 20:53:18 image_tesla.bin


SG350-28P#config
SG350-28P(config)#boot system usb://image_tesla.bin
% Unrecognized command
SG350-28P(config)# boot system usb://image_tesla.bin
% Unrecognized command
SG350-28P(config)#

**********************************************************************

 

So there was no upload but the feedback "%Unrecognized command".
I checked the CLI-REF Guide, and I think I did not wrote something wrong ...

 

As you can see, the USB-Drive has the FW-file on it (just with shortened renaming).

My user rights is 15, so there shouldn't be any block for me.

 

Andy advise what I am doing wrong ?

 

BR / Marc

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X