01-23-2017 01:49 AM
Good morning,
according to the CLI manual, release 1.4, page 980 ff. there is a "show environment" command similar to regular Cisco switches. When typing this command in the CLI there's a "Unrecognized command" error message.
Is there any way to get a read on the temperature via CLI, SNMP, ...?
Regards,
Joerg
01-23-2017 03:10 AM
Hi
what options does it give you in cli , use ? mark see whats available
show e ?
or try show power
01-23-2017 03:40 AM
show e
eee Energy Efficient Ethernet
errdisable Show errdisable state.
sh power shows the temperature of the PSU
01-23-2017 04:28 AM
strange doc says its there but not , maybe check your on the latest 1.4 release sx300_fw-1476.ros
01-24-2017 04:18 AM
Double checked: I'm on 1.4.7.6
01-23-2017 04:21 AM
I looked into the CiscoSB-Mibs and found only the PSU temp (OID .1.3.6.1.4.1.9.6.1.101.108.3.1.6.1) and the Temp status (OID .1.3.6.1.4.1.9.6.1.101.53.15.1.13.1).
Could get these infos via snmpget. So it's not the solution I was hoping for but better than nothing at all.
Thanks a lot for your help.
02-11-2019 04:41 PM
show system does this.
example:
FAN is OK
SYSTEM TEMPERATURE is OK
System Temperature Value: 23 Degree Celsius
System Temperature State: GREEN
Yellow Threshold : 51 Degree Celsius
Red Threshold : 61 Degree Celsius
SW PID Serial# Status Sys Pwr PoE Pwr Watts
--- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Good
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 <> <>
02-11-2019 11:22 PM
Hello,
Try the following commands:
switch# show system sensors switch# show system fan
Hope it helps
Cheers,
Mike
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: