I have a SG300 switch and there are smart port macros enabled on the user/phone ports, which is giving me a headache. On another SG300 switch, there are no smartport macro and things work as expected. I can define which VLAN is used for voice and the one which can be used as data, by using it as native VLAN. How do I disable this feature (cli, most preferably, if not, GUI) so I can set the VLANs as expected? VLAN 231 is used as data and 203 is used as Voice
Here's the messed config from my switch:
switch#sh run int gi4
interface gigabitethernet4
storm-control broadcast enable
storm-control broadcast level 10
storm-control include-multicast
port security max 10
port security mode max-addresses
port security discard trap 60
spanning-tree portfast
macro description "no_ip_phone_desktop | ip_phone_desktop"
switchport trunk allowed vlan add 231
!next command is internal.
macro auto smartport dynamic_type ip_phone_desktop
!
and how MAC address behaves on that port.
switch#sh mac address-table int gi4
Flags: I - Internal usage VLAN
Aging time is 300 sec
Vlan Mac Address Port Type
------------ --------------------- ---------- ----------
1 00:15:65:xx:xx:xx gi4 dynamic
231 00:15:65:xx:xx:xx gi4 dynamic
switch#
And on another switch, thins are as expected:
switch2#sh mac address-table interface gi22
Flags: I - Internal usage VLAN
Aging time is 300 sec
Vlan Mac Address Port Type
------------ --------------------- ---------- ----------
207 90:b1:1c:xx:xx:xx gi22 dynamic
switch2#
Regards,
Vitor
