cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
809
Views
5
Helpful
1
Replies

LACP configuration

Hi team,

 

i have one confusion on my mind,

i have configured lacp on a 3570 switch and i have allowed one native vlan on a trunk port in a port group of a lacp.

now my question is i have multiple vlan in the network is all vlan pass though the trunk port aur only native vlan will pass.

 

thanks in advance.

1 Accepted Solution

Accepted Solutions

Seb Rupik
VIP Alumni
VIP Alumni

Hi there,

If a switchport is operating in mode trunk, if you have not explicitly listed the VLAN IDs which you want enabled, then all VLANs will be tagged.

You can confirm this yourself with the command:

sh int <port-channel-x> switchport

 

...near the bottom of the output will be the line 'Trunking VLANs enabled: xxxx'

 

cheers,

Seb.

 

View solution in original post

1 Reply 1

Seb Rupik
VIP Alumni
VIP Alumni

Hi there,

If a switchport is operating in mode trunk, if you have not explicitly listed the VLAN IDs which you want enabled, then all VLANs will be tagged.

You can confirm this yourself with the command:

sh int <port-channel-x> switchport

 

...near the bottom of the output will be the line 'Trunking VLANs enabled: xxxx'

 

cheers,

Seb.

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X