08-07-2013 03:23 PM
I am going to purchase two Cisco SG200-26P switches with a MGBSX1 transceiver for each and connect them together via fiber. Am I correct to assume that the fiber port is configurable for VLANs? So if I configure four VLANS (1-4 on both switches, port 1 on VLAN1, port 2 on VLAN2, etc.), I can configure the fiber port to be on all four VLANS so that traffic for all four VLANS will move between the two switches?
Solved! Go to Solution.
08-07-2013 03:31 PM
Hi David, you are correct.
-Tom
Please mark answered for helpful posts
08-07-2013 03:31 PM
Hi David, you are correct.
-Tom
Please mark answered for helpful posts
08-08-2013 05:31 AM
Thanks very much; for the answer and for the quick reply!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: