cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

CISCO SWITCHES FOR SMALL and MEDIUM BUSINESS

Introducing the next generation of Cisco Small and Medium Business Switches. Cisco is refreshing its SMB Switch portfolio. Click here  to learn more.


3941
Views
3
Helpful
1
Replies
egemen1981
Beginner

Port mirroring

I want to configure port mirroring on SG300 swtich

Source Port  gi10

Destination port gi1

You can see my configuration from the attached jpg file.

Problem is port monitoring status is "Not Ready" , and i can not monitor the source interface!

1 REPLY 1
David Hornstein
Rising star

Hi Egemen,

I have the same thing happenning on my SG300-10P, see screen capture below.

Then I plugged some devices into ports G8 and G9.

It was noted that the  status changed to the following,  see screen capture below.

Check your link state on the front of the switch or use to GUI to look at the port states.  If one of those two ports does not have link,  the switch will report "not ready."

You may find additional useful information under status and statistics> view  log >ram memory can give you details about what is happening with port states, so check your error log.

( note: logging may have to be enabled via Administration >log settings )

regards dave

Create
Recognize Your Peers
Polls
How would you describe your level of technical expertise?