Problem with SG350XG-24F 24-Port 10G SFP+ Ports

[ِِِAbdalnoor S.Al-Tamimi]

all ports in specs must support 10G but i have some port i can't make 10G either from web or CLI and from CLI when executing command it shows Port  can not be configured to speed 10G

Thanks 

[marce1000]

 - So , what happens then or what kind of error are you getting when you try this ?

   M.

[ِِِAbdalnoor S.Al-Tamimi]

it shows Port can not be configured to speed 10G and in web browser only shows 1000 there is no 10000

[marce1000]

 - Check if this article can help you :

             https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-350x-series-stackable-managed-switches/smb5795-sg350x-sx550x-unable-to-change-xg-port-settings-on-a-switch.html

 M.

[ِِِAbdalnoor S.Al-Tamimi]

i have saw this topic and didn't found something that can help me , this image attached to port configuration available

[marce1000]

 - Try using latest firmware for your device anyway if not yet  done, then have a drive-through test by connecting a 10-Gb SFP+ with a connection, sometimes speeds get auto-configured. Check if the device reacts 'wisely' if  get's a 10 Gb connection to handle.

 M.

[mihail_ip]

Hello Abdalnoor,

what shows the following command:

switch# show inventory teX/0/X

where X is the port number in question

[ِِِAbdalnoor S.Al-Tamimi]

PID: SFP-1000-LX VID: Information Unavailable

[mihail_ip · Accepted solution]

Hi again Abdalnoor,

That is why you cannot go to 10gigabit - your SFP (SFP-1000-LX) is a gigabit one.

Try to replace it with 10gigabit - as per datasheet:

https://www.cisco.com/c/en/us/products/collateral/switches/350x-series-stackable-managed-switches/datasheet-c78-735986.html

SKU	Media	Speed	Maximum distance
SFP-H10GB-CU1M=	Copper coax	10 Gbps	1 m
SFP-H10GB-CU3M=	Copper coax	10 Gbps	3 m
SFP-H10GB-CU5M=	Copper coax	10 Gbps	5 m
SFP-10G-SR=	Multimode fiber	10 Gbps	26 m to 400 m
SFP-10G-LR=	Single-mode fiber	10 Gbps	10 km
SFP-10G-SR-S=	Multimode fiber	10 Gbps	26 m to 400 m
SFP-10G-LR-S=	Single-mode fiber	10 Gbps	10 km

Hope it helps

Regards,

Mike