You can configure the management VLAN on the SRW224G4 under Setup/Network Settings, but it'll only accept one vlan, so use either VLAN 10 or 20.
What you're trying to do might be done with a 'community VLAN' setup, but as i know the SRW224G4 does not support that, and it's a major pain to set it up.
To make things way more simple, you should forget the 'same IP range' thing, and configure two subnets, one for private, one for business. Then set up your router for both addresses, one for each VLAN. If your router can't work with VLANs, that'd make things even more complicated. It'd be nice to know the type of your router.
QuestionDear All,I'm currently looking for firmware version 188.8.131.52 for Linksys SPA400 Analog Telephony Gateway. Unfortunately, my device was bricked and I was able to recover it using a recovery tool and recovery firmware version 184.108.40.206 but can't find v...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...