Remote access from different network to SG350

[Jaro]

Hi All, 

I have configured cisco SG350, everything works fine, but I have a problem with remote access to this device from different vlan, from vlan where is configured sw sg350 I can access via http,https, ssh and I can also ping device, but from different VLAN I cannot even ping to SW.

Do you have any idea, what is a issue ?

Thanks in advance

[CiscoUser78652]

Hello Jaro

You have to enable VLAN Interface State -> Enabled (under VLAN Managment) and then assign IP (under IP Configuration).

Best regards

--

adam

[Jaro]

Hi,

Vlan interface status was enabled....I do not have problem with access from same network as cisco SG350 is configured, I have a problem to access to cisco SG350 from different network (it is not problem of FW, allowed any any), I cannot either ping SW.

Thank you

[Sujoy Paria]

Hi Jaro,

Please check the following settings…

• IPv4 Routing is enabled under IP Configuration >> IPv4 Interface.
• Remote system (on different VLAN on that switch) gateway is configured as the SVI (Switched Virtual Interface) IP configured on that switch for the respective VLAN.

[Jaro]

Hi, 

Finnaly I found a solution, switch is configured as L2, without L3 routing.

I forgot basic thing, to add ip default gw.

Now it works.

[Sujoy Paria]

Hi Jaro,

Good to know that the issue has been resolve now.