Series 200 - Open TCP ports

[KingridgeDr]

Hi there,

Please excuse my ignorance, as I have no familiarity with Cisco products.

I have a Cisco series 200 switch, and I'm trying to open a few TCP ports (81, 8097, 8098 and a few others) on it, so that I can communicate with my NAS. For the life of me, I can't figure out how to do this, on this switch. 

Will someone please advise me on how to do this, or point me towards some documentation?

Thanks in advance!

Jay

[devils_advocate]

Hi Jay

Assuming the switch is in its default configuration then it will not be blocking any ports unless someone has configured it to do so. I am not even sure if the 200 series can block ports.

If you can ping your NAS from a PC/Laptop then all ports should be open between them.

Thanks

[KingridgeDr]

Hi Devil's,

Thanks for the response. I appreciate it. I do believe you're right. I think that my router was blocking the ports, that I'd previously opened. I was able to resolve the issues.

Thanks.