SF300 CLI - How to change IP, with L3 enabled ?

[Athena1390]

Hello,

I have a SF300-48P (Firmware 1.0.0.27).

I wanted to enable L3, and the configuration was renewed (OK, I knew that).

Then, I'm not able to modify the IP : I set it to static, and it kept the IP provided by the DHCP.

There is no way to modify this management IP via the GUI.

I enabled Telnet (SSH cannot be enabled...) and connected via Putty.

But, I have a menu (not the CLI), and I'm not able to change the IP via that menu (error : duplicate IP).

And I cannot obtain the CLI, even when typing Ctrl-Z.

How can I :

- Modify the IP, with L3 enabled

- Have access to the CLI

Thanks in advance for your help.

[V K Moorthy]

Hi

Command line:

switch#config

switch(config)#int vlan 1

switch(config)#ip add 192.168.20.5 255.255.255.0

Try this

[Athena1390]

Hi, thanks for this answer.

I know that I have to execute this command in the CLI, however the problem is the access to the CLI.

When connecting with telnet, I have a menu, but not the CLI itself.

And I don't know how to switch from this menu to the CLI (Ctrl-Z doesn't work).

[Tom Watts]

Please update the firmware. Cli was not available on this release.