SF300 no Ethernet response

[fmarshall]

I'm working to configure some new SF300-08 switches.  They are at firmware 1.4.10.6 which I believe is the latest release.

One of them is working fine.  The other, fresh out of the box, updated firmware with the http interface OK but is acting strangely.  

I started configuring it via http and then just lost it.

Mostly, the power light is blinking fairly rapidly and the Ethernet ports aren't working.

I can access the console interface OK.  It shows all the Ethernet ports are Up.

How can I get this to recover?

[balaji.bandi]

As per the document :

The power led flashing continuously is an indication of the default ip address is being used.

quick start guide.

http://www.voipsupply.com/downloads/dl/file/id/151/cisco_300_series_switches_quick_start_guide.pdf

Same trouble at the below link.

https://supportforums.cisco.com/discussion/11764411/sf300-24p-system-light-flashing

[Glenn Martin]

hello fmarshall,

When did this start? what color is the LED? typically inidicates powering up, acquiring IP Address, or system failure.

If it continues after doing a hard reset you should contact Customer Experience.

[fmarshall · Accepted solution]

The LED was always green - blinking or not.

I found the problem and the switch has been configured successfully.

Thanks!