03-15-2015 11:10 AM
I have a SF500-48P switch and and have several VLANs on it (over 25 vlans).
Each of these ports shall support also an IPPhone on vlan 4.
I was thinking about using LLDP so I won't have to setup the VLAN manually on each phone.
But when I do here what's happening,
Original configuration:
Port 25:
Vlan 35 untagged
When I plug the phone, the configuration changes to:
Vlan 1 untagged
Vlan 4 tagged
I was expecting the following:
Vlan 35 untagged
Vlan 4 tagged
Note that ports 1-25 have their own individual VLAN and need to be isolated (already done ACL in the router).
I need help,
regards,
03-15-2015 08:24 PM
03-16-2015 07:48 AM
What about my other ports that belongs to other Vlans (11-24)?
With the steps you gave me, as soon I connect a Phone, the untagged Vlan becomes 35 for any ports where a phone is connected.
Since I have several Vlans untagged (only 1 per port), I don't want the untagged vlan to be changed by the smartport settings. Is there a way to do that?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: