cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

CISCO SWITCHES FOR SMALL and MEDIUM BUSINESS

Introducing the next generation of Cisco Small and Medium Business Switches. Cisco is refreshing its SMB Switch portfolio. Click here  to learn more.


1740
Views
0
Helpful
1
Replies
Highlighted
Beginner

SG 300-20 and Service Electric cable modem

I am somewhat new to this level of networking and have run into a problem that I cannot seem to overcome...

I have an SG 300 switch that I had configured, and had working just fine, at my old residence using a DSL line. Since moving, I have changed over to a cable modem and find that my previous configuration does not work. Is there anything that needs to be changed since what I had set up worked before?

My current configuration is as follows:

Motorola Surfboard SB6121 connected to a Netgear WNDR4000. SG 300 (Layer 3) is configured with 5 VLANS, IP 10.1.x.1 for the interfaces and static route added to point traffic to 10.1.5.254 (router). The router is configured with static routes back to the VLANs using 10.1.5.1 as the return interface. The computers are all configured to use 10.1.x.1 as the default gateway, and have appropriate IP addresses in the same range.

I can ping everything internal, and can resolve names to IP on the internet, but cannot get a response, nor access any website on the internet. I have tried 2 different routers and 2 different cable modems, so that leads me to think that I have one or more settings incorrect on the switch.

If anyone can steer me in the right direction, I would truly appreciate it.

1 REPLY 1
Advocate

SG 300-20 and Service Electric cable modem

Hi Matt, here is a topic I responded to a while back. This example uses a RV0XX router with a SX300 switch.

https://supportforums.cisco.com/thread/2123434

-Tom
Please rate helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/