cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

CISCO SWITCHES FOR SMALL and MEDIUM BUSINESS

Introducing the next generation of Cisco Small and Medium Business Switches. Cisco is refreshing its SMB Switch portfolio. Click here  to learn more.


426
Views
0
Helpful
3
Replies
Peter_sgc_2
Beginner

SG_300 VLAN Configuration

Hello,

I am setting up a network on some SG300 switches, I've used Cisco Catalyst switches in the past and I'm trying to configure Port_28 as the Trunk and then the other ports in different VLANs (100-120 etc).

Now I would normally use commands like;

     switchport access vlan 111
     switchport mode access

For access ports

and;

    switchport mode trunk

For connections to the Cisco 2800

But this switch talks about "Tagged" "Untagged" "Excluded" "PVID"

And when you set a Port to Access you can't seem to set a VLAN but you can in General Mode??

 

Can anyone explain the basic config? or Explain "Tagged" / "Untagged" "Excluded" etc..?

 

I am using 802.1q encapsulation on the 2800 Side for the Trunk. 

3 REPLIES 3
jer0nim0x
Beginner

Can you see if page 238-239 in the Administration Guide (Chapter 14) helps?

Do you have a link to the guide? 

The one I have Chap-14 is STP and the one online is Chap-14 Configuring Multicast Forwarding 

 

Who would have guessed that the SMB would be harder to configure then the Catalyst ...

http://www.cisco.com/c/en/us/support/switches/sg300-10-10-port-gigabit-managed-switch/model.html

 

Depends on your FW version