cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

CISCO SWITCHES FOR SMALL and MEDIUM BUSINESS

Introducing the next generation of Cisco Small and Medium Business Switches. Cisco is refreshing its SMB Switch portfolio. Click here  to learn more.


398
Views
0
Helpful
0
Replies
Highlighted
Beginner

SG-350 Voice and Data Vlan Setup questions

Hello,

I am hoping someone can help point me in the right direction here, I am looking for quite a basic setup. We have just purchased 6 x SG-350 and I am having trouble working out if my config is right.

 

I am used to Catalyst IOS and these switches have all this auto configuration/macros and do not support the IOS commands which I am familiar with. 

 

I am seeing two different Configs: GUI vs SSH which concerns me. Port Vlan Membership in GUI shows me 200 untagged?

 

I have yealink IP phones with a switch port so the PC and Phone Share same cable. 

 

End result I am trying to achieve.

Vlan 1 - Data - Untagged

Vlan 200 - Voice - Tagged

Gig 1 - Trunk Port connected to Cisco Router - allowing Vlan 1 and 200 access.

All other Switch Ports ports allow Vlan 1 &  Vlan 200.

QOS/Cos to prioritize Voice.

 

Current Config:

vlan database
vlan 200
exit
voice vlan id 200

voice vlan oui-table add 0001e3 Siemens_AG_phone________
voice vlan oui-table add 00036b Cisco_phone_____________
voice vlan oui-table add 00096e Avaya___________________
voice vlan oui-table add 000fe2 H3C_Aolynk______________
voice vlan oui-table add 0060b9 Philips_and_NEC_AG_phone
voice vlan oui-table add 00d01e Pingtel_phone___________
voice vlan oui-table add 00e075 Polycom/Veritel_phone___
voice vlan oui-table add 00e0bb 3Com_phone______________

bonjour interface range vlan 1

!
interface vlan 1
ip address 192.168.1.250 255.255.255.0
no ip address dhcp
!
interface vlan 200
name Voice
ip address 192.168.201.250 255.255.255.0
!
interface GigabitEthernet3
spanning-tree link-type point-to-point
switchport mode trunk
macro description switch
!next command is internal.
macro auto smartport dynamic_type switch
!
interface GigabitEthernet4
switchport general allowed vlan add 200 tagged
switchport general allowed vlan add 1 untagged
switchport access vlan 200
!

Questions:

1. Does my config look ok?

2. Do I use enable Auto Voice Vlan if I don't have any supported phones?

3. Can I remove all these voice vlan oui-table add lines ?

 

GUI Screesnhots:

 

1.PNG2.PNG3.PNG4.PNG5.PNG6.PNG