cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
778
Views
5
Helpful
1
Replies

SG-350 Web UI becomes unresponsive

I am configuring an SG-350 from scratch. Upon login using factory credentials, I go to create a vlan as I am looking to segment ny switch with two vlans. I want to have 2 vlans: 1) one port on a management vlan and 2) the remainder of the ports on another vlan. Creating the vlans and doing the Port Vlan membership is straightforward. However, when I try to set an ipv4 address for the new vlan under IP management->IPv4 Interface, my web UI crashes. I ultimately need to power cycle the switch to get the UI back.  

1 Reply 1

marce1000
VIP
VIP

 

                      > ...my web UI crashes.

 - What do you mean by that ? What is observed in the browser ?

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X