cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1396
Views
0
Helpful
5
Replies

SG-350X not showing the correct LAG speed

Hi,

 

I have an SG 350-X stack ( of two switches ) which is connected to a Juniper switch with 6 cables in a LAG group. From the Juniper switch I can see that the LAG speed is 6 Gig,  but from the Cisco side I see only I Gig. Is there any way I can make sure that the LAG on Cisco side is operating at 6G or 1G ? . I did not enable LACP on both sides. The screen shot from Cisco is attached.

 

Thanks 

5 Replies 5

Iliya Gatsev
Cisco Employee
Cisco Employee

Hi,

My name is Iliya Gatsev from Cisco Technical Support Team.

 

Are you using SFP or RJ-45 ports on the Cisco switches ? Could you share screen shot from the LAG Management page of the Cisco and from the Juniper if you don't mind ?

 

 

Iliya Gatsev
Cisco STAC Network Engineer
Together we are the human network .:|:.:|:. CISCO

hi;

RJ-45 ports on the Cisco switches and Juniper , please find attached requested screen shot.

 

Regards.

 

Hello Mohammed,

Can you issue the command in CLI (console or SSH):

switchxxxxxx# show interfaces status

 

and paste here the output 

Hi Mipopov;

 

please  find below :

 

PFQ-USER-SW#show interfaces status
                                             Flow Link          Back   Mdix
Port     Type         Duplex  Speed Neg      ctrl State       Pressure Mode
-------- ------------ ------  ----- -------- ---- ----------- -------- -------
gi1/0/1  1G-Copper      --      --     --     --  Down           --     --
gi1/0/2  1G-Copper      --      --     --     --  Down           --     --
gi1/0/3  1G-Copper      --      --     --     --  Down           --     --
gi1/0/4  1G-Copper      --      --     --     --  Down           --     --
gi1/0/5  1G-Copper      --      --     --     --  Down           --     --
gi1/0/6  1G-Copper      --      --     --     --  Down           --     --
gi1/0/7  1G-Copper      --      --     --     --  Down           --     --
gi1/0/8  1G-Copper      --      --     --     --  Down           --     --
gi1/0/9  1G-Copper      --      --     --     --  Down           --     --
gi1/0/10 1G-Copper      --      --     --     --  Down           --     --
gi1/0/11 1G-Copper      --      --     --     --  Down           --     --
gi1/0/12 1G-Copper      --      --     --     --  Down           --     --
gi1/0/13 1G-Copper      --      --     --     --  Down           --     --
gi1/0/14 1G-Copper      --      --     --     --  Down           --     --
gi1/0/15 1G-Copper      --      --     --     --  Down           --     --
gi1/0/16 1G-Copper      --      --     --     --  Down           --     --
gi1/0/17 1G-Copper      --      --     --     --  Down           --     --
gi1/0/18 1G-Copper      --      --     --     --  Down           --     --
gi1/0/19 1G-Copper      --      --     --     --  Down           --     --
gi1/0/20 1G-Copper      --      --     --     --  Down           --     --
gi1/0/21 1G-Copper      --      --     --     --  Down           --     --
gi1/0/22 1G-Copper      --      --     --     --  Down           --     --
gi1/0/23 1G-Copper      --      --     --     --  Down           --     --
gi1/0/24 1G-Copper      --      --     --     --  Down           --     --
gi1/0/25 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi1/0/26 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi1/0/27 1G-Copper    Full    1000  Enabled  Off  Up          Disabled On
gi1/0/28 1G-Copper      --      --     --     --  Down           --     --
gi1/0/29 1G-Copper    Full    100   Enabled  Off  Up          Disabled Off
gi1/0/30 1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi1/0/31 1G-Copper      --      --     --     --  Down           --     --
gi1/0/32 1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi1/0/33 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi1/0/34 1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi1/0/35 1G-Copper      --      --     --     --  Down           --     --
gi1/0/36 1G-Copper      --      --     --     --  Down           --     --
gi1/0/37 1G-Copper      --      --     --     --  Down           --     --
gi1/0/38 1G-Copper      --      --     --     --  Down           --     --
gi1/0/39 1G-Copper      --      --     --     --  Down           --     --
gi1/0/40 1G-Copper      --      --     --     --  Down           --     --
gi1/0/41 1G-Copper      --      --     --     --  Down           --     --
gi1/0/42 1G-Copper      --      --     --     --  Down           --     --
gi1/0/43 1G-Copper      --      --     --     --  Down           --     --
gi1/0/44 1G-Copper      --      --     --     --  Down           --     --
gi1/0/45 1G-Copper      --      --     --     --  Down           --     --
gi1/0/46 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi1/0/47 1G-Copper    Full    1000  Enabled  Off  Up          Disabled On
gi1/0/48 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
te1/0/1  10G-Combo-C    --      --     --     --  Down           --     --
te1/0/2  10G-Combo-C    --      --     --     --  Down           --     --
gi2/0/1  1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/2  1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi2/0/3  1G-Copper      --      --     --     --  Down           --     --
gi2/0/4  1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi2/0/5  1G-Copper    Full    100   Enabled  Off  Up          Disabled On
gi2/0/6  1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/7  1G-Copper      --      --     --     --  Down           --     --
gi2/0/8  1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/9  1G-Copper    Full    1000  Enabled  Off  Up          Disabled On
gi2/0/10 1G-Copper      --      --     --     --  Down           --     --
gi2/0/11 1G-Copper      --      --     --     --  Down           --     --
gi2/0/12 1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi2/0/13 1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/14 1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi2/0/15 1G-Copper      --      --     --     --  Down           --     --
gi2/0/16 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi2/0/17 1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/18 1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi2/0/19 1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/20 1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/21 1G-Copper    Full    10    Enabled  Off  Up          Disabled On
gi2/0/22 1G-Copper    Full    10    Enabled  Off  Up          Disabled Off
gi2/0/23 1G-Copper      --      --     --     --  Down           --     --
gi2/0/24 1G-Copper      --      --     --     --  Down           --     --
gi2/0/25 1G-Copper      --      --     --     --  Down           --     --
gi2/0/26 1G-Copper      --      --     --     --  Down           --     --
gi2/0/27 1G-Copper      --      --     --     --  Down           --     --
gi2/0/28 1G-Copper      --      --     --     --  Down           --     --
gi2/0/29 1G-Copper      --      --     --     --  Down           --     --
gi2/0/30 1G-Copper      --      --     --     --  Down           --     --
gi2/0/31 1G-Copper      --      --     --     --  Down           --     --
gi2/0/32 1G-Copper      --      --     --     --  Down           --     --
gi2/0/33 1G-Copper      --      --     --     --  Down           --     --
gi2/0/34 1G-Copper      --      --     --     --  Down           --     --
gi2/0/35 1G-Copper      --      --     --     --  Down           --     --
gi2/0/36 1G-Copper      --      --     --     --  Down           --     --
gi2/0/37 1G-Copper      --      --     --     --  Down           --     --
gi2/0/38 1G-Copper      --      --     --     --  Down           --     --
gi2/0/39 1G-Copper      --      --     --     --  Down           --     --
gi2/0/40 1G-Copper      --      --     --     --  Down           --     --
gi2/0/41 1G-Copper      --      --     --     --  Down           --     --
gi2/0/42 1G-Copper      --      --     --     --  Down           --     --
gi2/0/43 1G-Copper      --      --     --     --  Down           --     --
gi2/0/44 1G-Copper      --      --     --     --  Down           --     --
gi2/0/45 1G-Copper      --      --     --     --  Down           --     --
gi2/0/46 1G-Copper    Full    1000  Enabled  Off  Up          Disabled On
gi2/0/47 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
gi2/0/48 1G-Copper    Full    1000  Enabled  Off  Up          Disabled Off
te2/0/1  10G-Combo-C    --      --     --     --  Down           --     --
te2/0/2  10G-Combo-C    --      --     --     --  Down           --     --

                                          Flow    Link
Ch       Type    Duplex  Speed  Neg      control  State
-------- ------- ------  -----  -------- -------  -----------
Po1      1G      Full    1000   Enabled  Off      Up
Po2         --     --      --      --       --    Not Present
Po3         --     --      --      --       --    Not Present
Po4         --     --      --      --       --    Not Present
Po5         --     --      --      --       --    Not Present
Po6         --     --      --      --       --    Not Present
Po7         --     --      --      --       --    Not Present
Po8         --     --      --      --       --    Not Present
PFQ-USER-SW#

Does anybody find a solution for this? I am having the same issue.