02-01-2014 01:27 AM
Hi there,
There seems to be a problem with some switches that it doesn't allow us to change the untagged VLAN in the smartport macro.
This causes a problem: if we change it manually when we apply the smartport it works fine but if the switch reboots the smartport is reapplied with the VLAN set in the macro, this puts the port onto the worng VLAN which is not good.
Please help.
02-01-2014 12:06 PM
Hi Gerrard, you can modify the macro for the native VLAN.
Check this post
https://supportforums.cisco.com/thread/2177613
-Tom
Please mark answered for helpful posts
02-03-2014 02:36 PM
Hello Gerrard,
This is actually a currently known issue. When you try to update the native VLAN on a smartport macro it looks like it has taken effect, but never really gets updated. I have confirmed the same issue on a device here in the lab.
Give us a call at 1.866.606.1866 and we can create a support case for you and try to get that issue resovled.
Thank you for choosing Cisco,
Christopher Ebert
----
Senior Network Support Engineer - Cisco Small Business Support Center
*Please rate helpful posts*
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide