sg200-08p on 11-14V DC?

[lyrnxg]

Hello, does anyone use or know if a sg200-08p can run fine between 11-14V DC?  I am looking to power it from a battery.  Thank you

[balaji.bandi]

it required 12V DC as per the document, it should be ok as long as it can not go beyond 12V

[lyrnxg]

Have you or anyone else tried feeding more voltage? A lot of modern technology can handle over voltage.

[balaji.bandi]

Not that i have tried, Cisco do not recomend to use any 3rd party input adpator to use other than recommended one, since you willing to test - so that is the advise was suggested.