05-03-2021 01:11 PM
Hello, does anyone use or know if a sg200-08p can run fine between 11-14V DC? I am looking to power it from a battery. Thank you
05-04-2021 02:56 AM
it required 12V DC as per the document, it should be ok as long as it can not go beyond 12V
05-04-2021 06:13 AM
05-04-2021 07:45 AM
Not that i have tried, Cisco do not recomend to use any 3rd party input adpator to use other than recommended one, since you willing to test - so that is the advise was suggested.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: