cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
578
Views
0
Helpful
2
Replies

SG300-10MPP on a large network

cwangskr
Beginner
Beginner

Can I use the SG300-10MPP on a lager layer 2 network ( lager than class C).  I have layer 2 switch with vlan1 ip is 141.225.215.224/22 and default-gateway is 141.225.212.1 and with this config I am unable communicate with switch or switch can't communicate with tacacs, radius, etc. I can't even ping the default-gateway from the switch, but if I change the vlan ip to 141.225.212.18/22 ( same class C range as default-gateway) every thing works fine.

2 Replies 2

Tom Watts
Advisor
Advisor

Hi Chandra, I could not recreate this. I have created a SVI at 141.225.212.1 /22 on a switch then I took a layer 2 switch and assign it 141.225.215.224 with gateway 141.225.212.1. This is able to ping successful from within either switch.

Do you have any special routing such as a VRF, VPRN, Route protocol (OSPF, BGP, etc) ?

-Tom
Please mark answered for helpful posts
http://blogs.cisco.com/smallbusiness/

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Tom,

141.225.212.1 (cisco WS-C4506-E) is running OSPF. I open a TAC with Cisco and they spend almost a half a day trying to figure out the problem. Finally they send me a new switch and it is doing the same thing. The PC's I connect to the switch have no problem communicating with network, only issue I have is management of the switch.  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: