cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1262
Views
0
Helpful
1
Replies

SG300-10SFP - Optical Module Status problem

Tomas Chott
Beginner
Beginner

Hello,

i have installed SG300-10SFP switch in one customer site, port g1-g9 is for customers and g10 for uplink to Metropolitan network

after installation, all working fine, in port g10 i have installed SFP CWDM with DDI (diagnostics) all data like Temp, signal etc... switch displays correctly, after 60days i can check DDI info, but now switch displays only "N/A" value

i can try reboot, but same value in WEB or CLI, in port status is all OK port is connected

i have firmware

1.3.5.58

screen of status in attach

1 Reply 1

Tom Watts
Advisor
Advisor

Hi Thomas, investigating.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: