05-06-2012 04:07 PM
Quick overview of my setup:
4 Buildings all interconnected by Fiber in 1 LAN. 4 Vlans - Data (Default Vlan), Voice 1, Voice 2, and Guest. The vendor doing phones reccomended 2 Voice Gateways for their installation thus requiring 2 seperate Voice Vlans.
Building A and B are on Voice 1
Building C and D are on Voice 2
Building A has Gateway 1 which runs on Voice 1 (Vlan 52)
Building C has Gateway 2 which runs on Voice 2 (Vlan 53)
Building A/B/C are all working great. The switches in Building D for some reason keep wanting to use Vlan 52 (Voice for Building A/B) in it's configuration even though I set the Voice Vlan to 53. So If I disabled the Auto Voice Vlan the phones get no LLDP settings and do not work at all.
Is anyway I can configure the switch to use Vlan 53 as the primary voice vlan? My other option is to configure my DHCP with all the options but since its working on 5 out of 7 switches I'd like to get these other 2 switches working also.
Or is there a way I can disable it but keep LLDP so I do not have to configure the DHCP settings? If not I will just disable.
03-16-2014 01:41 PM
Hi Gregory, it is possible the uplink port at building D is receiving an advertisement to configure the voice VLAN as VLAN 52 either via CDP or LDP.
Try to disable the autosmart port macro for the uplink port and CDP/LDP for that particular link and see if it helps that situation.
03-20-2014 07:47 PM
Hi Gregory,
As I can understand you have 4 switches
switch A for 1st switch, switch B for 2nd switch, switch C for 3rd switch, switch D for 4th switch.
first you need to loging to switch A and do this following
config t
Switch A# config t
Switch A<config>
Switch A<config># spanning-tree priority 0
end
config t
Switch B# config t
Switch B<config>
Switch B<config># spanning-tree priority 4096
end
config t
Switch C# config t
Switch C<config>
Switch C<config># spanning-tree priority 8192
end
config t
Switch D# config t
Switch D<config>
Switch D<config># spanning-tree priority 12288
end
now we need to fix vlan issue
I will give you example and you need to try it in your switch
this switch support only 1 voice vlan work with smartport so if you want config two voice vlans you need to use other vlan as this following
config t
Switch A# config t
Switch A<config>
Switch A<config># int range gi1-3
Switch A<config-if-range># switchport mode trunk
Switch A<config-if-range># switchport trunk allow vlan add 52
Switch A<config-if-range>#switchport trunk native vlan 1
Switch A<config># int range gi4-6
Switch A<config-if-range># switchport mode trunk
Switch A<config-if-range># switchport trunk allow vlan add 53
Switch A<config-if-range>#switchport trunk native vlan 1
end
wish my issue will help
Thanks,
Moh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: