06-15-2020 08:58 AM
Hello,
I have a Cisco SG350-10P Switch.
My POE Devices do not power up after a reboot. I have to go into POE settings and toggle Class / Port settings, then the devices power up.
I have saved the running config file as the startup file and even exported the config file and verified the settings.
Do I have a faulty switch?
06-15-2020 10:21 AM
- You may want to verify all required settings again using this guide :
M.
06-15-2020 12:49 PM
I'm using the same settings on other SG300 & SG350 switches I have in my inventory. I just find this issue with 1 particular unit.
All I have to do is toggle the Port/Class setting, then the ports power on.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: